Windshield washer fluid reservoir — removal and installation

1. Loosen the left front wheel lug nuts, then raise and support the front of the vehicle securely on jack stands. Remove the wheel.

2. Remove the inner fender liner (see Fender liner — removal and installation).

3. Remove the two screws securing the wheel house forward bracket.

4. Remove the windshield washer hose and the electrical connector to the washer pump.

5. Remove the four bolts securing the reservoir (see illustration).

11.5 Lower reservoir mounting screws

Chevrolet Silverado _ Lower reservoir mounting screws

Note: Two of the screws are accessed from the top side. They are attached to the battery tray.

6. Remove the reservoir out through the wheel well.

7. Installation is the reverse of removal.

  • Pages

    open all | close all