Shift level (manual-shift models) — removal and installation
1. Raise the front of the vehicle and sup- port it securely on jack stands.
2. Remove the transfer case skid plate, if equipped.
3. Remove the front driveshaft (see Driveline).
4. Use a small screwdriver to release the control rod at each end. Remove the control rod.
5. Remove the knob from the lever by put- ting a wrench under the knob and tapping the wrench upwards with a hammer.
6. Remove the three bezel screws and remove the bezel. 7 Remove the four lever bolts and lift out the lever assembly.
8. Installation is the reverse of removal.